Model #WM2801HRA LG Residential Washers

  • Cabinet And Control Panel Parts
    3 Results
  • Drum And Tub Parts
    3 Results
  • Dispenser Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Tub won't turn sometimes during wash cycle WM2801HRA Lg Washer

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your washer and I do understand your frustration. Glad to help out. I'm looking at your model number WM2801HRA and from your description I would suspect an issue with the stator. Here is a link that will help test the stator. The other problem could be the bearing but you have indicated that you do not hear and noises coming from the bearings. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
February 17, 2015
A:

Mr. Wallace, I replaced the stator today. Installed the new rotor and ran the washer. It did fine for a few minutes but started hanging up like before. Again, I have listed all the parts I have replaced and I can spin the tub freely by hand and don't notice any noise or rough spots. Any other suggestions on where to go from here would be greatly appreciated

Read More
Johnny -
February 24, 2015
See more answers
Q:

LG Washing Machine drain problem.

A:

A washer is definitely something we depend and when starts malfunctioning it can be a big inconvenience. I have attached a link below that give great information on way this may be happening. Hope it helps!

Read More
Yadira B -
September 04, 2012
A:

Hi Yadira, Thanks for the direction. Using the post you mentioned, and few more others on the internet, I did the steps I mentioned in my original post. And have reached a point where I am looking for specific technical inputs or cop-out to changing the motor-pump assembly.

Read More
Virendra -
September 04, 2012
A:

Hello Virendra. It sounds like you have ruled out the drain path between the pump and the washer drain as a cause of this problem. If you have not checked that drain path between the tub and the pump, then I recommend that you examine that issue. If that drain path is clear and the pump is buzzing in the drain mode then you will probably need to replace that drain pump. The pump will run periodically in the spin/drain portion of the cycle.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
September 05, 2012
See more answers

Top Parts