Model #WLSR2200J3WW GE Residential Washers

  • Controls & Backsplash
    3 Results
  • Cabinet, Cover & Front Panel
    3 Results
  • Tub, Basket & Agitator
    3 Results
  • Suspension, Pump & Drive Components
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

my agitator doesn't work

A:

I understand how important it is for your Washer to be working so that you can do your laundry without any further delay and although your Washer is not working properly, I will be happy to help. While you are waiting for an expert answer, I did mange to find a few links that will provide you with more information about your problem.

Read More
Priscilla V -
March 22, 2011
A:

If the washer will spin then the motor and belt, there is no coupler on this model, are most likely okay.

I suspect the problem would be the water level switch or timer.

The image below may help with is.

A few more details might also help. Does the washer motor seem to run in the agitation cycle?

If the washer will spin then the lid switch is most likely okay. A bad lid switch would prevent the washer from agitation or spinning.

I hope this helps give you some ideas. Thanks for the question but if you can reply with a few more details I may be able to pin this problem down.

Read More
Fred M -
Sears Technician
March 23, 2011
A:

no sir the motor does not run or make any noise when in agiataion cycle. i took the agitator off and the agitator coupler off , the teeth are all good on the inside and out. no wear and tear.

Read More
tanna abbott -
March 23, 2011
A:

If the motor will run in the spin cycle but does not run in agitation then the problem is most likely the timer. If you remove the agitator there should be a piece mounted on top of the transmission held on by one bolt. Remove the coupling and if the transmission is not turning then the transmission is likely the problem. If the motor will spin but will not agitate then the timer is most likely at fault.

Read More
Fred M -
Sears Technician
March 26, 2011
See more answers

Top Parts