Model #WFW8300SW00 WHIRLPOOL Residential Washers

  • Cover Sheet
    3 Results
  • Top And Cabinet Parts
    3 Results
  • Door Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What part number do I need? WFW8300SW00

A:

Water Temperature Sensor Error

If during the Wash Cycle in the water-heating step, the water temperature sensor (NTC) valve is out of range (-5 degrees Cto 103 degress C).
Note: To find correct Ohm reading refer to the Water temperature sensor section.

Possible Causes/Procedure
1. Unplug washer or disconnect power.
2. Check the water temperature sensor and connection to it.
3. Check resistance of heating element, if present on this model. (abnormal = infinity)
4. Refer to the Water temperature sensor section of manual.

Read More
Ernest7574 -
Sears Technician
November 23, 2015
Q:

Whirlpool Duet Sport washer won't finish cycles

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your washer. Upon researching modelWFW8300SW00; the “F01” error code indicates a communication problem error between the central control board and the motor control board. This error code could also indicate a pump driver that fails to activate.  This unit has 3 control boards the F01 error code is normally due to the machine control board part#W10525351, if you have already replaced this board then the motor control board (part# W10197864) may have failed.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
March 02, 2015
Q:

Sam Colleen: WFW 8300 SW00

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your washer. Upon researching modelWFW8300SW00; the “F01” error code indicates a communication problem error between the central control board and the motor control board. This error code could also indicate a pump driver that fails to activate.  This unit has 3 control boards the F01 error code is normally due to the machine control board part#W10525351, if you have already replaced this board then the motor control board (part# W10197864) may have failed.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
March 02, 2015

Top Parts