Model #W104 JENN-AIR Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Internal Controls
    3 Results
  • Door
    3 Results
  • Oven
    3 Results
  • Blower Motor (cooling Fan)
    3 Results
Find part by diagram >

Question and Answers

Q:

i have a kenmore front loader washer the model #is110.4778.1701 im havin trouble with ...suds code...f35 code...and now f21 code.....

A:

Error codes can be an inconvenience and keep your washer from working. I am sorry that you are having some difficulties with your washer and I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your washer troubles while you wait for your expert response.

Read More
Joseph P. -
September 19, 2012
A:

my machine is a kenmore not whirlpool ...thks

Read More
MICHELLE -
September 20, 2012
A:

Michell - Although your washer is branded 'Kenmore' it was manufactured by Whirlpool. Sears and Kenmore do not manufacture anything.

Read More
biguggy -
September 20, 2012
A:

That part W10156252 is the same as part W10415587. Since you replaced the water level pressure sensor (part W10156252) then that sensor should be working properly. You indicated that you were seeing the SUDS code and the F21 code. You did not mention whether the washer was draining properly. If there is excessive suds in the tub, the washer will not be able to drain. I recommend that you check for foam or excessive suds in the tub when you are seeing that code. If you do see foam or suds, I recommend that you drastically cut back on the amount of HE (High Efficiency) detergent that you are using. If you are not using HE detergent, then this could cause excessive suds. You should only need about 1 tablespoon of HE detergent per load of wash.

If you see no suds, I recommend that you see if the washer will go through the cycle with no clothes (and no detergent added). If the washer is not draining, then you could have debris clogging the drain, the drain hose or the drain pump. You can check the washer drain and the drain hose for a clog. The image below shows a procedure for accessing and checking the large item filter on the drain pump. I recommend that you unplug the washer and check that area if necessary. Position a shallow pan (baking pan) under that pump clean-out filter before removing it. If the washer is full of water, be sure that you manually drain the water out before removing that large item filter.

If you are seeing that F21 code constantly and it won't clear, I recommend that you unplug the washer for 5 minutes. That should reset the control board. Plug the washer back in and see if the controls will work properly.

These initial tips may help you with this problem. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
September 20, 2012
See more answers