Model #U5780-900 HOOVER Vacuum, Upright

  • Handle/main Housing
    3 Results
  • Motor & Housing/nozzle Base
    3 Results
Find part by diagram >

Question and Answers

Q:

how to replace or repair cord rewind

A:

I can understand your need for some type of instructions on how to properly replace the cord rewind on your Hoover vacuum. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Julio -
March 14, 2013
A:

I don't have service information for that model of Hoover Windtunnel Vacuum Cleaner. You can view the parts diagram for the vacuum on this page: Hoover Vacuum Cleaner Model U5780-900 Repair Parts.

 

You may be able to determine how to access the cord rewind component using that information. I am not sure whether Hoover will be able to advise you on the disassembly of the vacuum. You can call Hoover at 1-800-944-9200 to ask for additional assistance.

 

If you get to the point where you need to have a service technician repair the vacuum cleaner, you can carry it into your nearest Sears Store or Sears Repair Center. 

Read More
Lyle W -
Sears Technician
March 16, 2013
See more answers
Q:

Windtunnel vacuum shuts off by itself.

A:

I understand that your Wind tunnel vacuum cleaner shuts off on its own. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below if you are interested in viewing. I hope the link that I provided is helpful. Have a great day.

Read More
Alina F. -
June 26, 2011
A:

Thank you for your question.

I can understand your concern for the vacuum cleaner shutting down when it gets hot and having to wait for it to reset before you are able to use it again.

It sounds like the vacuum is overheating and then shuts down from thermal over heat. Then as it cools it will reset the thermal overload and you are able to use it again.

I would suggest that you make sure all the filters are clean in the vacuum and that all the hoses are clean of any restrictions.

Seeing that the cord is hot I would suggest that you take the vacuum in for service to make you do not damage the motor.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
June 27, 2011
See more answers