Model #U5434-900 HOOVER Vacuum, Upright

  • Handle/hose/housing
    3 Results
  • Hood
    3 Results
Find part by diagram >

Question and Answers


I am replacing the power cord on a hoover windtunnel model U5434-900. How do I release the power cord 'release'.


Having a working vacuum is a necessity. I found some information for you that I am hoping will help you with the vacuum. I am adding the link below to help you with your question while you wait for your expert response. I do hope that this will help you with the vacuum.

Read More
Marc -
July 29, 2012

Thank you for your question on the replacement of the power cord for the Hoover vacuum cleaner. Is the cord to big for the hole or is there a cord retainer you will have to remove?

There should be a cord strain relief that you will have to remove in the back body of the vacuum cleaner. You will have to use a pair of pliers to pinch the cord retainer strain relief and work it out of the back of the vacuum cleaner.

Then measure the length of the wire from the location of the old strain relief and put it in the same location on the new cord and put the cord through the hole in the vacuum body and squeeze to pinch the wire and install into the back of the vacuum body.

Please let me know if that was your issue and if not please reply and we can continue with a little more information.

Sam A.

Read More
Sam A -
Sears Technician
July 31, 2012
See more answers