Model #TS300 DELTA Saw Table

  • Table And Cabinet
    3 Results
  • Blade/motor/shaft
    3 Results
  • Stand
    3 Results
Find part by diagram >

Question and Answers

Q:

Weslo TS 300 tread mill model 831.294620

A:

I understand that your tread mill runs the highest when the key is inserted. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful.

Read More
Alina F. -
February 17, 2011
A:

This problem is caused by a failed controller board. The board "thinks" it is being sent a signal when it isn't. The only fix for this is to replace the controller board (pt. number 137856). I wish I had better news but I'm afraid the controller is the problem.

You can order a new controller HERE with the part number I listed.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
February 18, 2011
See more answers
Q:

Why doesn’t the speed control on my Weslo Cadense ts300 model 831.294660 work?

A:

Speed control not working could be caused by many problems. By your question I’m not clear on what the treadmill is doing. If the treadmill will not run at all here are some checks to make:

UNPLUG THE TREADMILL

  • Check the connections in the console.
  • Remove the cover over the motor and check the connections on the motor control board.
  • The harness in the uprights might be pinched and broke.
  • Plug the treadmill in and slide the key in watch the motor control board it should have a led on.
  • When you turn the speed up another led will start to flash indicating it is receiving the signal from the speed control.
  • If the led is flashing the motor and or the motor control will need to be replaced.

Please resubmit your question with more detail for further assistance.

Read More
Mark T Personal Solutions Manager -
Sears Technician
November 23, 2009

Top Parts