Model #SW5L40D SUPRA Laundry Centers/Combos

  • Front Panel Assy
    3 Results
  • Cabinet Parts
    3 Results
  • Water Pump Assy
    3 Results
  • Door Assy
    3 Results
  • Ac Power Assy
    3 Results
  • Water Supply
    3 Results
  • Drum Assy
    3 Results
  • Motor/heater Assy
    3 Results
  • Detergent Box
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

No heat with Edgestar washer/dryer combo CW1210V or Model SW5L40

A:

Having an appliance that is not working can take up a lot of time. The information you entered should help the expert provide the guidance needed for this repair. I found and attached the owner's manual and the link to the schematics and parts at Sears Parts Direct for the unit. Hope this helps!

Read More
Barbara H. -
August 07, 2010
A:

I don't have technical information on this model of washer/dryer combo. I have the parts list diagram and a wiring diagram and that is the extent of information available to me. It appears that you can access the heating element for the dryer by unplugging the unit and removing the top panel. Before replacing that element, you can check the resistance through the element to see if it is good. Remove at least one wire from the element and measure the resistance across the leads of the element with a volt/ohm meter. If you get a resistance reading between 5 and 40 ohms then the heating element should likely be heating and may be okay. If you read Ol (open load or infinite resistance) then the element is definitely bad and will need to be replaced. That is the only suggestion that I have regarding this repair. If the heating element is okay, you could have a bad timer, a failed thermostat (there are several in the circuit) or a wiring failure that would prevent the element from heating. I recommend that you have service technician diagnose and repair this problem if the above tips don't help.

Read More
Lyle W -
Sears Technician
August 09, 2010
See more answers