Model #SF310PEAW0 WHIRLPOOL Range (gas)

  • Cooktop
    3 Results
  • Cooktop Burner
    3 Results
  • Broiler & Oven Burner
    3 Results
  • Control Panel
    3 Results
  • Oven
    3 Results
  • Oven Rack
    3 Results
  • Door And Broiler
    3 Results
Find part by diagram >

Question and Answers

Q:

Where is the igniter module located and what is the part #? How is it replaced? SF310PEAW0 Whirlpool Range (gas)*

A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when needing your oven will not spark correctly. I did take a look at the model number you have provided and I was able to find the spark module for your unit.

 

First you will need to unplug the unit and turn off the gas valve.

 

Access the rear of the concole and remove the screws from the back. Pull out on the panel to remove.

Take smaller panel off on the right hand side of the unit, after removing the first larger panel.

 

The spark module is right under the smaller panel and you will need to disconnect the wires. Make sure you take notes or pictures on where exactly the wires go so you can install the new module correctly.

 

Let me know if this helps.

 

Thank you for your question. Have a great day.

 

Read More
Natasha12 -
Sears Technician
October 04, 2013
A:

Thank you. Do you know the part number of the spark module and do you think I'm correct in thinking this is causing the problem?

Read More
Joel -
October 04, 2013
A:

Yes it is 4371030. It cuold be causing the problem. It does state that the module controls the spark and if that is not working or going out then you would need the module.

Read More
Natasha12 -
Sears Technician
October 04, 2013
A:

The spark module is only for the top burners. What color is the flame in your oven?

Read More
Natasha12 -
Sears Technician
October 04, 2013
A:

Flame in broiler area under the oven is blue. Glow plug is orange. Your instructions above were perfect. I took the two panels off and there it was. Looks like it'll be easy to replace. I'm going to order the part after you reply to this note concerning the flame color for the oven. Thank you very much.

Read More
Joel -
October 04, 2013
A:

Okay I recommend checking the OHM meter on the igniters.

 

 

If you're not getting a spark when you turn the oven on, then there are several possibilities:
  • There could be a problem with the switch in the thermostat. You can confirm this by doing a simple continuity test of the thermostat contacts. If you don't read zero ohms when you turn the switch on, replace the thermostat.
  • The spark module could be bad. You'll need to measure the voltage at the oven terminals of the spark module when you turn on the oven. If you get 120v but no spark, it's probably a bad spark module. Replace it.

 

Read More
Natasha12 -
Sears Technician
October 08, 2013
A:

Spark module came in today. Took me about ten minutes to replace. Everything works perfect again. Super big thank you to Natasha12. You made it easy. Thanks again, Joel

Read More
Joel -
October 09, 2013
A:

That is Great to hear Joel, I am glad you have your Range back up and running. Thank you for choosing Sears Parts Direct. Have a great day.

Read More
Natasha12 -
Sears Technician
October 10, 2013
See more answers