Model #S2100E4WW GE Residential Washers

  • Controls & Backsplash
    3 Results
  • Cabinet, Cover & Front Panel
    3 Results
  • Tub, Basket & Agitator
    3 Results
  • Suspension, Pump & Drive Components
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Agitator Coupler

A:

I am sorry that you are having some difficulties with your washer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. Click here for the link. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
June 15, 2013
A:

I know that it can be very frustrating to have issues with your washer. From what you described it sounds like the agitator, air bell, or transmission is failing. Since the unit spins we know the belt and motor is ok. I recommend removing and inspecting the agitator and air bell. If they are not stripped out then you have a transmission failure. Or, start the washer at the beginning of a cycle set to the lowest water level. After the unit fills and should be agitating stop the washer. Open the lid and try moving the agitator, if the agitator will not move it is good & no need to remove for inspection. You have a bad transmission. If the agitator moves easily then we know that the agitator or air bell is stripped out and will need to be inspected for confirmation before replacing. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 16, 2013
See more answers
Q:

Why does the water level run over on my GE washer?

A:

The pressure switch trips on the air pressure that builds up in the air dome on the bottom of the outer tub that has a small pressure hose attached to it & the pressure switch in the console. If the air dome is breeched or the pressure hose has a crack or is crimped the pressure switch will not sense the pressure & the unit will overfill. It is possible that the new pressure switch is faulty also. I recommend checking the air dome & pressure hose.

Read More
biker dave -
Sears Technician
April 02, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show