Model #RF395LXEB0 WHIRLPOOL Free Standing, Electric

  • Cooktop
    3 Results
  • Control Panel
    3 Results
  • Chassis
    3 Results
  • Drawer And Broiler
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Whirlpool Range Model RF395LXEB0

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
December 31, 2011
A:

Thank you for your question and I understand your concern.

The "F3/E2" fault code indicates the oven reached a too high of temperature. This can be caused by a faulty oven temperature sensor probe or electronic oven control. The sensor is more likely faulty rather than the electronic oven control board.

I recommend replacing the oven temperature sensor located inside the oven cavity. It can be found inside the oven cavity protruding from the rear wall. Open the oven door and remove the oven racks. Remove the two screws securing the sensor probe to the bake panel and slowly pull it towards you. You may have to cut and splice the wires together using the ceramic wire nuts supplied with the replacement sensor.

The part number of the sensor is #8053344 which can be ordered from Sears PartsDirect .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 03, 2012
A:

TY for your comments. Befor I order this part, besides the error code, now the broiler element is on 100% of the time as long as power is appied. All other functions with the cook to operate fine. I have to unplug or turn off the breaker to keep the broier or top element from heating.

Read More
Thomas -
January 03, 2012
A:

Thomas: Based on your additional details if the complete broil element is glowing red then I suspect a stuck relay on the electronic oven control board. This means the oven control board will need to be replaced. If the only a small portion of the broil element is glowing red then the broil element is likely shorted to ground.

Read More
Joey S -
Sears Technician
January 03, 2012
A:

TY. I am afraid the complete element is on and my research showed that the control board is no longer available. I have already ordered a new range as this one is 15 years old . I may tinker with this one once I install the new one. I appreciate your response.

Read More
Thomas -
January 03, 2012
See more answers

Top Parts