Model #RES7648EQ2 ROPER Residential Dryer

  • Cabinet
    3 Results
  • Top And Console
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Question and Answers

Q:

I am having a problem with my Roper Dryer starting

A:

I'm sorry about the difficulties that you are experiencing with your Roper Dryer. I did some research at managemylife.com and found an expert answer to a similar question that may assist you until your expert can respond. Please note that it is a different model # but it still may shed some light on the scope of work and difficulties of the repair. I have attached the link below. If you would like to schedule service and have a qualified technician help you, I have also attached a link to searshomeservices.com. I hope these links will help until your expert can respond.

Read More
James -
February 11, 2011
A:

While the push to start is a possibility the first thing I suggest you check is the thermal fuse.

It is located behind the rear panel. See the image below.

The fuse can be checked for continuity with an ohm meter or if a meter is not available then it can be bypassed.

Remember to unplug the dryer first.

To bypass the fuse will require a small piece of insulated wire. Remove the two wires from the fuse and join them together. If the dryer runs then the fuse is bad. The 3392519 fuse can be obtained from the following site: Sears PartsDirect .

I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
February 12, 2011
See more answers

Top Parts