Model #RBD305PRS00 WHIRLPOOL Built-In Oven, Electric

  • Lower Oven Parts
    3 Results
  • Upper Oven Parts
    3 Results
  • Upper And Lower Oven Door Parts
    3 Results
  • Upper And Lower Oven Door - Ss Models
    3 Results
  • Internal Oven Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Top Venting Parts, Optional Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

display is out but oven lights and beeps still working RBD305PRS00 Whirlpool Built in oven - electric

A:

Thank you for your question and I understand your concern.

It could have a faulty power supply transformer or a faulty control board. The thermal fuse in the voltage circuit powering up the control transformer could be blown too.

I added a couple of images below with the procedure of accessing the control transformer, transformer fuse and control board. NOTE: Disconnect the oven from the power source before servicing. 

You will need an Ohm meter to test the control transformer and fuse.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
October 22, 2013
A:

hi, can you email me the images? I tried clicking on them but too small to see. Thanks...

Read More
MICHAEL -
February 17, 2014
See more answers
Q:

Display is blank RBD305PRS00 Whirlpool Built in oven - electric

Q:

How to access thermal fuse on whirlpool double oven RBD305PRS00?

A:

Having a working oven is very important. I found some information for you that I am hoping will help you until your expert answers your question. I am adding the link below to help you with your question while you wait for your expert response. It may take your expert 24-48 hours. I do hope that this will help you with the oven.

Read More
Marc -
September 11, 2012
A:

That thermal fuse is located behind the control board. It is shown in the first image below. The second image shows that fuse circled in red on the wiring diagram. You should be able to access it by shutting off the house circuit breaker for the oven and removing the top panel above the control box. Carefully pull the oven far enough out of the cabinet to pull off that top panel.

If you need more help, reply with additional details.

If you get to the point where you need to have a service technician examine and repair the oven, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 12, 2012
See more answers

Top Parts