Model #PSD267LHES MAYTAG Side-by-Side Refrigerator

  • Refrigerator Door (series 10)
    3 Results
  • Freezer Door (series 10)
    3 Results
  • Handles (series 10)
    3 Results
  • Fountain (series 10)
    3 Results
  • Hinges (series 10)
    3 Results
  • Controls (series 10)
    3 Results
  • Refrigerator Shelves (series 10)
    3 Results
  • Crisper Assembly (series 10)
    3 Results
  • Freezer Shelves (series 10)
    3 Results
  • Evap Fan/crisp Light/filter (ser.10)
    3 Results
  • Evaporator/rollers/water Tank (ser.10)
    3 Results
  • Freezer Compartment (series 10)
    3 Results
  • Compressor (series 10)
    3 Results
  • Cabinet Back (series 10)
    3 Results
  • Ice Maker (series 10)
    3 Results
  • Ice Bucket Assy. (series 10)
    3 Results
  • Supplemental Information (series 10)
    3 Results
  • Wiring Information (series 10)
    3 Results
  • Refrigerator Door (series 50)
    3 Results
  • Freezer Door (series 50)
    3 Results
  • Handles (series 50)
    3 Results
  • Fountain (series 50)
    3 Results
  • Hinges (series 50)
    3 Results
  • Controls (series 50)
    3 Results
  • Refrigerator Shelves (series 50)
    3 Results
  • Crisper Assembly (series 50)
    3 Results
  • Freezer Shelves (series 50)
    3 Results
  • Evap Fan/crisp Light/filter (ser.50)
    3 Results
  • Evaporator/rollers/water Tank (ser.50)
    3 Results
  • Freezer Compartment (series 50)
    3 Results
  • Compressor (series 50)
    3 Results
  • Cabinet Back (series 50)
    3 Results
  • Ice Maker (series 50)
    3 Results
  • Ice Bucket Assy. (series 50)
    3 Results
  • Supplemental Information (series 50)
    3 Results
  • Wiring Information (series 50)
    3 Results
Find part by diagram >

Question and Answers

Q:

Freezer freezes up

A:

I can understand your concern with the problem you have with the Kenmore refrigerator freezer. A similar question has been answered in the link provided below. An expert response to your specific model may take 24-48 hours. If you decide on service, that link is also available below.

Read More
Anna T -
January 14, 2013
A:

I added some technical information in the images below that may help you (or you and your friend) further diagnose this problem in your refrigerator. The first image shows how to place the control in a Forced Defrost mode. That will often help you determine whether the defrost heater is working.

If not, you can use the information in the second image to check that defrost heater. You should measure around 29.3 ohms (+/- 7%) through the orange and white wires on the control board (or directly at the heater if that is where you are measuring it). You should measure the same resistance through the brown and white wires (the white wire is traced in hot pink on that diagram). If the heater is okay but that defrost bi-metal thermostat is "open" (measure OL -- open load or infinite resistance) then that thermostat will need to be replaced. Note: The defrost termination thermostat will normally be "open" if the temperature in that area of the evaporator is above 42 degrees F). If the heater is bad, then that heater will need to be replaced. You can order parts from this page: Maytag Refrigerator Model PSD267LHES Parts . Be sure that you unplug the refrigerator before accessing internal components and replacing parts.

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 16, 2013
A:

Here are the images.

Read More
Lyle W -
Sears Technician
January 16, 2013
See more answers
Q:

refrigerator mod # psd267lhes no water to icemaker from back of refrig

A:

I know how important it is to have a good working ice maker in the home so that you can enjoy some ice cold beverages. While you are waiting for your expert answer, I did manage to find a link that will provide you with some good information to help you with your question to help you with your question. I hope my link is useful.

Read More
Joseph P. -
September 06, 2011
A:

If water is dispensing at the dispenser, but not filling the icemaker, fill the ice mold with water and wait 3-4 hours to see if the icemaker harvests the ice. If the icemaker does not harvest the ice, you need to replace the icemaker.

If the icemaker does harvest the ice the problem is in the water fill. Remove the cover from the front of the icemaker. Make a jumper wire from # 14 wire and strip 1/2 inch insulation from both ends. Be very careful with the jumper wire as you are dealing with live current. If you are not comfortable doing this test, don't attempt it. You can go to Home Services and get a Sears technician to repair the refrigerator.

If you are comfortable to proceed, jump terminals L and V. Water should run into the icemaker immediately. Listen for the hum of the solenoid on the water valve.

If no water runs and you hear no hum, replace the water valve. If you hear a hum and no water, the fill tube to the icemaker is probably frozen up.

If you have questions, reply on this thread with details and I will be glad to help.

Read More
Jimmy K -
Sears Technician
September 08, 2011
See more answers

Top Parts