Model #PLHS269ZCB2 FRIGIDAIRE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

WATER FILTER MODEL: KENMORE NGFC2000 PLHS269ZCB2 Frigidaire Refrigerator

Q:

My refrigerator won't cool. It seems like the compressor isn't running. How can I be sure it's the run capacitor?

A:

It raises anxiety when the refrigerator stops cooling. First there is the food stored and secondly repair costs may be expensive. The expert will review this model and your specific question. I did locate a similar question that may be helpful. If scheduling repair is needed, I also added the link to Sears Home Services below. I hope this information is helpful if needed.

Read More
Barbara H. -
April 19, 2012
A:

A technician would normally check the voltage going to the compressor first. I posted a wiring diagram in the image below. If the compressor is getting run voltage then you could have a bad start relay or a bad capacitor if your refrigerator has a capacitor installed on that start relay. You should not check that live voltage yourself unless you are completely confident that you can safely measure it. Wear electrical safety gloves and safety goggles if you check that voltage going to the compressor. Unplug the refrigerator as soon as live testing is completed . If that compressor is getting voltage, then I recommend that you unplug the refrigerator and remove that start device from the compressor. Shake that start relay and see if it rattles. If it does, then that start relay is probably bad. You can order a new start relay from this page: Start Relay for Frigidaire Refrigerator PLHS269ZCB2 . If you suspect that the capacitor is bad, you can check it with a meter. It should measure 15 microfarads.

If the start relay and the capacitor are both okay, then you could have a bad compressor. A service technician would need to repair that type of failure. Here is a link for the Sears Service website: Sears Home Services .

If the compressor is not getting voltage, you could have a wiring failure or a bad control board.

If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
April 22, 2012
See more answers

Top Parts