Model #PLHS267ZAB5 FRIGIDAIRE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Refrigerator getting too cold

A:

I am glad to hear you feel confident in fixing the Frigidaire refrigerator and our experts are here to help.  Check out the link provided below, it is on a similar issue.  Hope this is helpful while waiting for additional information on your specific model. 

Read More
Anna T -
March 18, 2013
A:

Thank you for your question. I understand your concern about the fridge section freezing. There is a complete updated control panel assembly # 5303918283 designed to correct this type of problem. This can be a complicated panel to install and a technician may be needed. This panel is available at Sears PartsDirect. If you would like more assistance, reply to this thread and I will assist you further.

Read More
Scott D -
Sears Technician
March 19, 2013
See more answers
Q:

Frigidaire evaporator frozen over

A:

Defrost system not working, but as I am not converant with that model will await pearls of wisdom from someone who is.

Read More
biguggy -
December 04, 2011
A:

I'm sorry to hear that you are having some difficulties with your refrigerator. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Barbara H. -
December 04, 2011
A:

Thank you for your question. I'm sorry you are having this problem. This will be a problem with the defrost system. A good check to help determine what the cause of the problem is, will be to manually put the unit into a defrost cycle. This is done by pressing the light switch 5 times in 6 seconds. When this is done, the unit should stop running and it will now be in a defrost cycle. After a few minutes if you can hear a sizzling sound inside the freezer, it will mean the heating element and defrost thermostat are both ok. In this case, the Defrost Control Board (ADC) # 240554502 will need to be replaced. It's available at SearsPartsDirect . If you do not hear anything, some voltage and resistance checks will need to be made. A technician may be needed to make these checks. I hope this will help you. If you would like more assistance reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
December 07, 2011
See more answers
Q:

Frigidaire Ice Maker leaks into ice bucket.

A:

I understand your concern toward your ice maker leaking water in your bucket. While you are waiting for an expert answer, I recommend you resubmit your question including the model number of refrigerator so that the expert will provide you with a more detailed answer. I also managed to find a link that will provide you with more information about your problem please be sure to read the expert answer first. I hope my link is useful.

Read More
Joseph P. -
October 16, 2010
A:

Joseph, thank you for the information. if you read my post completely you would find that the model number and brand is posted above, i will repost for easier veiwing: Brand: Frigidaire Model Number: PLHS267ZAB5 thank you for the link to the other post but i don't belive this is the same issue as i don't have big blocks or lack of dispensing. if someone else has information that would be much appreciated.

Read More
PUEET -
October 17, 2010
A:

I cannot tell from the picture whether the leak is caused by a failed water valve or a crack in the ice mold. If you are able to unplug the refrigerator and remove the ice maker, you can check the mold for a crack. If you see water constantly dripping from the fill tube then a failed water valve is likely causing your problem. If you shut off the water supply and the leaking stops, then this can verify that you have a leaking supply valve for the ice maker.

If you see not visible problem with the ice mold but suspect that it is leaking, you can keep the water shut off and manually fill the ice mold to see if water still leaks out of it.

These tips may help you determine the cause of your problem.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
October 18, 2010
A:

Lyle, thanks for the suggestions, here are a couple key things: when i break off the ice chunk and leave it in the off position it doesn't seem to leak. the ice comes out formed properly and never has trouble dumping it how difficult is it to remove to check for a crack compared to how would i fill it to see if there is a crack in the mold? Thanks!!!!

Read More
PUEET -
October 18, 2010
A:

Since the water does not leak when the ice maker is off, the water valve is probably not causing this problem. The image below shows how to adjust the water fill level and test cycle the ice maker. You may need to reduce the fill level using this information. This may help you resolve this leaking issue. If you still think that the ice mold is cracked, you can UNPLUG the refrigerator and remove the ice maker by taking out (or loosening) the screws that attach it to the side wall of the freezer. You may need to unplug the wiring harness if you are going to pull it all of the way out. Check the fill tube that protrudes into the freezer as well. You may also need to check the fill cup at the back of the ice maker for a crack. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
October 19, 2010
See more answers

Top Parts