Model #PLEB30S9DCA FRIGIDAIRE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Driver shape PLEB30S9DCA

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating what type of driver you need for the retainer screw. 

You can use an allen wrench for the center or hex socket for the head. I do apologize we do not have the exact size. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 



Read More
Natasha12 -
Sears Technician
October 29, 2014
Q:

My Frigidair Pro Series model PLEB30S9DCA will not cause heating elements to heat. Sensor has been replaced. What else could cause this.

A:

I see you have been making some repairs to your Frigidaire oven. While you wait for the expert to review your model, you might check a general answer from a previous post that lists some other possible causes. If you do decide to hand off this repair to a technician , an option is the Sears Home Services link below.

Read More
Barbara H. -
September 18, 2011
A:

You could have a tripped safety thermostat on the back of the oven that is causing this problem. I assume that you already checked the house circuit breakers or fuses for the oven. The oven will power up if only the L1 leg of power is supplied to the oven. If the second L2 leg of power is missing, the elements will not heat. If the house circuit breakers are okay, you could have a tripped thermostat that would prevent the elements from getting power through that L2 side of the circuit. The first image below shows the wiring diagram for this range with that safety thermostat circled in green and the L2 voltage supply to the control board traced in red. The second image shows the physical location of that safety thermostat and also shows a photograph of the component. That safety thermostat has a red reset button on it. I recommend that you shut off the house circuit breaker for the oven and pull it out of the cabinet to access that safety thermostat on that outside back panel of the oven. Push that red button to reset the safety thermostat and reassemble the range. Check to see if the elements will heat after resetting that thermostat.

If the elements still don't heat after resetting that thermostat, you could have a bad safety thermostat, a failed relay on the control board in the console, a voltage supply problem or a wiring failure. Be sure that you shut off the house circuit breaker for the oven before accessing internal components if you check these issues yourself. Reply with additional details if you need more help repairing this failure.

If you need parts, you can order them from the Sears PartsDirect website.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 21, 2011
See more answers

Top Parts