Model #MV1610WW GOLDSTAR Microwave/Hood Combo

  • Door Parts (i)
    3 Results
  • Controller Parts (i)
    3 Results
  • Oven Cavity Parts
    3 Results
  • Latch Board Parts
    3 Results
  • Interior Parts (i)
    3 Results
  • Interior Parts (ii)
    3 Results
  • Installation Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Re: Goldstar Over-the-Range microwave MV1610WW

A:

Managemylife.com is always a great resource to find the answers to just about anything. I know this information can be very helpful for you to have. While you have been waiting for your expert to respond, I did some research but I was unable to locate information that would be helpful with regards to your question at this time. Your expert will be answering you within two business days but usually sooner.

Read More
Anna T -
December 10, 2012
A:

That microwave was shipped in the recirc mode. When it was installed, the motor was rotated to a position that would allow it to vent through the top of the microwave or out of the back of the microwave. The procedure for rotating that fan for external venting is shown in the images below. That process will need to be reversed to rotate the fan so that is will blow the exhaust air out of the vent in the front of the microwave. The first 3 images below have the information that should help you rotate that fan. Be sure that you unplug the microwave before you begin this process. You can reverse the mounting procedure shown in the 4th image to pull the microwave down from the cabinet.

You will need to order the charcoal filter (part 5230W1A011B). That filter will need to be installed as shown in the owner's manual (page 23). Here is a link for that owner's manual in case you need it: Owner's Manual . You may also need a new mounting plate that is circled in the 5th image. That is part number 4960W1A022A. You can order those parts and any others that you need from this page: Goldstar Microwave Model MV1610WW Parts .

I hope that this information helps you convert that microwave back to the recirculation mode. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
December 11, 2012
A:

Here are the 4th and 5th images.

Read More
Lyle W -
Sears Technician
December 11, 2012
A:

Mr. Lyle W, you are my hero! Thank you so very much. This is exactly what I needed, and presented in a very easy-to-comprehend explanation (complete with images no less!) for this very non-mechanically inclined, visual person. My sincere thanks to you, truly. Lori

Read More
Anonymous -
December 11, 2012
See more answers

Top Parts