Model #MSD2957AEW MAYTAG Side-by-Side Refrigerator

  • Compressor
    3 Results
  • Controls
    3 Results
  • Shelves & Accessories
    3 Results
  • Freezer Compartment
    3 Results
  • Fresh Food Outer Door
    3 Results
  • Fresh Food Inner Door
    3 Results
  • Freezer Outer Door
    3 Results
  • Freezer Inner Door
    3 Results
  • Fountain
    3 Results
  • Ice Maker
    3 Results
  • Ice Bin (rev 10)
    3 Results
  • Ice Bin (rev 11)
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Question and Answers

Q:

My refrigerator maytag model MSD2957AEW is not cooling. The compresser, fan, and lights all work.

A:

I am sorry that you are having some difficulties with your refrigerator and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
February 04, 2013
A:

Thank you for your question. I know it's frustrating when the refrigerator stops working. If it�s not cooling at all and if the compressor is running, the problem will probably be in the seal system or with the compressor. It could be a low charge, a restriction or the compressor may not be pumping properly. These are checks a technician will be required to make. I'm listing a site you can access, to have a tech come out. Here is a link for the website: Sears Home Services . If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
February 05, 2013
See more answers
Q:

how to test a electronic control frig model is #msd2957aew

A:

I understand that you want to test the electronic control board on your refrigerator. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question. Have a great day!

Read More
Alina -
July 20, 2012
A:

Thank you for your question. This model has an electronic defrost control and dispenser board. If you would like to place this into a defrost mode to test the defrost board, a jumper wire will be needed to jump the L1 and test terminals (see attached information). This is a hot (live) check and you will need to be very careful. This can be a difficult test and a technician may be needed. To check the fountain board, it will depend on the type of problem. I hope this will help you. If you would like more assistance, reply to this thread with more details and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
July 23, 2012
See more answers
Q:

What are the symptoms of a bad thermostat?

A:

There are 3 main symptoms of a bad thermostat:

  1. It may run all the time, causing the temperatures to get too cold.
  2. It can shut off too soon, causing warmer temperatures then desired or needed.
  3. The switch contacts can stick open, not allowing the unit to run. Sometimes by turning the thermostat all the way off and back on again, will free the contacts.
These are the 3 main symptoms of a bad thermostat. I hope this helps you. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
October 09, 2009

Top Parts