Model #MJ9000V MAJESTIC APPLIANCE Laundry Centers/Combos

  • Cabinet Parts
    3 Results
  • Tub/drum Asy
    3 Results
  • Electric Parts
    3 Results
  • Blower
    3 Results
Find part by diagram >

Question and Answers

Q:

The plastic latch on door broke. Is there a part to replace it MJ9000V Majestic Appliance Washer/dryer

Q:

Dryer won't heat, smelled like it was over heating MJ9000V Majestic Appliance Washer/dryer

A:

Thank You for choosing Sears PartsDirect.com. It is unfortunate to hear that you are having issues with your washer dryer combo and I do understand your frustration. Glad to help out. I'm looking at your model number mj90000v and yes I suspect the same. I recommend checking the fan motor and the thermostat. If you have a multimeter you can test and see if you have power at the motor. I hope this information helps with your troubleshooting.  If you have further questions please resubmit your question for further information.
 
Thank you for choosing Sears PartsDirect.com.
 
 
 
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
July 29, 2014
Q:

how do I frt to the blower so I can change the heat element mj9000v

A:

Thank You for choosing Sears PartsDirect.com. I regret to hear that you are having issues with your laundry center 
and do understand your frustration. Glad to help out. Im looking at your model number and first unplug the unit.
?Remove the top panel (Two screws behind and slide back)
?The heating element is located inside the heater housing.
?Unfix the support to the heater housing. (4 bolts on the top)
?Unfix the upper heater housing. (3 screws and a few clamps)
?Unfix the two nuts and remove the heating element.
?Replace the same and do the wiring as before / below.
?Fix all the parts back by following the reverse procedure.

Testing Procedure:
?Hot Test:1) Set the washer knob on off position and the dryer knob on 30.2) You should get 115V AC across the terminals of the heating element.3) Check if the unit is heating up, if so the heating element is good. Here is a link for the page (page 25) that has this information and I recommend reviewing before attemtping the repairs. I hope this information helps with your repair. Just click the blue link above to be taken to the page. If you have further questions please resubmit your question for further information.
 
Thank you for choosing Sears PartsDirect.com.
 
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.
 


esting Procedure:
?
Hot Test:
1) Set the washer knob on off position and the dryer knob on 30.
2) You should get 115V AC across the terminals of the heating element.
3) Check if the unit is heating up, if so the heating element is good.

Read More
Sherman_G_Wallace -
Sears Technician
June 24, 2014