Model #MDG6400AWW MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
  • Gas Valve
    3 Results
  • Motor Drive
    3 Results
  • Tumbler
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

pulley MDG6400AWW Maytag Maytag laundry

A:

Thank you for your question and I understand your concern.

I must assume if you were able to remove the motor pulley I assume it threaded off. Some motors come with the pulley pressed on or made onto the motor shaft. 

If the first two digits of the serial number of your Maytag dryer begins with a 10 or below, you will need to order the motor and pulley assembly.

If the serial number begins with 12 or above then the motor pulley must have threaded on and off or is held onto the motor shaft with a set screw.

It appears since the parts list does not show the motor pulley, you will likely need to order the motor that comes with the pulley attached to the motor shaft from the manufacturer.

I was not able to locate the pulley by the number you found on the pulley. I recommend calling Sears Parts Direct at 1-800-366-7278 and see if they can get the motor pulley. If your pulley did not thread on, then you will need to replace the motor assembly.

Read More
Joey S -
Sears Technician
September 23, 2013
Q:

Maytag gas dryer #MDG6400AWW

A:

It can be very aggravating when your dryer malfunctions and will not cycle nor heat properly. I did some research and provided a link to a similar question and answer on our site. I hope this will shed a little more light on the issue until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
December 28, 2012
A:

When a gas dryer is running but not heating the key to the problem is knowing what the ignitor is doing. If the ignitor doesn't glow then the problem might be the temperature switch, thermostat, high limit thermostat or radiant sensor. It might even be a bad ignitor. The front panel can be removed so visually check if the ignitor is glowing or not. If the ignitor glows and clicks off with no flame then the gas valve or coils are likely to blame. The image below may assist you in removing the front panel. I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
December 29, 2012
See more answers

Top Parts