Model #MDE7460AYW MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
  • Gas Valve
    3 Results
  • Heater
    3 Results
  • Motor Drive
    3 Results
  • Tumbler
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Maytag Dryer Model #MDE7460AYW will not turn off. MDE7460AYW

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
July 12, 2013
A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

Wes sorry about the problems that you are having with your dryer.   One thing to check Wes.  Seee if you have a vent restriction.   Pull the dryer away from the wall and run a cycle with no vent on at all and see if you have the same problem.   If it works then check  your dryer vent to the outside to make sure  you don't have clogs anywhere.  Is the timer hooked up correctly? (have to ask).   I will also suggest you to take off the timer knob and see if it will advance.   If it does then you know the knob is bad.   After all of that testing, then we may have to assume your timer is not good.   Good luck.

If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com

Read More
Larry L -
Sears Technician
July 12, 2013
See more answers
Q:

Maytag Dryer

A:

A dryer is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Barbara H. -
January 07, 2012
A:

Thank you for your question and I understand your concern.

If the material was attached in the center area of the outer surface of the drum, it�s likely a sound dampener and it will operate normally without it.

Now, if the material was located at one of the ends of the drum, it is a drum seal and it must be in place in order to heat and dry properly.

If the seal has been pulled out; I highly recommend calling a service technician to reinstall or replace the seal.

You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 10, 2012
See more answers

Top Parts