Model #MDB6601AWW MAYTAG Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Water Distribution Assembly
    3 Results
  • Pump & Motor
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Track & Rack Assembly
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

water level MDB6601AWW Maytag Dishwasher

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Looking at the information the water level in this dishwasher is within 1/4" to just touching the bottom of the heating element. The water level is not designed to be above the heating element. Hope this information has help you, any further questions or concerns please feel free to comment back, thanks.

Read More
Samantha A -
Sears Technician
May 22, 2014
Q:

How to fix my Maytag dishwasher wihch starts and stops 4 times before turning off

A:

I'm sorry about the difficulties you continue to have with your dishwasher. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Yadira B -
November 18, 2012
A:

From the description you give I suspect the motor is the problem. The motor has an overload that will reset. If you have a meter then I would suggest you check the resistance of the motor windings. The images below may help you with this. Remember to turn the power off first. Since the control did run the diagnostic test I suspect the control is okay.

Read More
Fred M -
Sears Technician
November 19, 2012
See more answers
Q:

Is my electrical hooked up correctly?

A:

I understand the importance of having the correct wiring for the dishwasher. I have taken the time to research on the Manage My Life website and have located a link that you may find useful. While you are waiting for an expert to reply I have attached the link below.

Read More
Priscilla V -
July 19, 2011
A:

Thank you for your question and I understand your concern.

The power supply should have the proper polarity first. The power supply to the dishwasher should have a Black wire, White wire and bare copper wire for ground. The Black wire should be the hot wire (L1) which should be connected to Black wire on the dishwasher, the White wire is the neutral wire which should be connected to the White wire on the dishwasher and the bare copper wire is ground which should be connected to a ground screw on the chassis next to electrical junction box under the dishwasher.

Read More
Joey S -
Sears Technician
July 21, 2011
See more answers

Top Parts