Model #MDB5601AWS MAYTAG Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Track & Rack Assembly
    3 Results
  • Tub
    3 Results
  • Water Distribution Assembly
    3 Results
  • Pump & Motor
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Maytag 300 quiet series dishwasher

A:

I am sorry that you are having some difficulties with your dishwasher and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your dishwasher troubles while you wait for your expert response.

Read More
Joseph P. -
August 29, 2012
A:

The image below shows the pin-out test for the control console key panel on that dishwasher. If you have a volt/ohm meter with precision (needle) probes, then you can use that information to check the Start button on your key panel. Be sure that you shut off the house circuit breaker for the dishwasher to completely disconnect electrical power before accessing internal components. Based on your symptoms, that Start button on the console is probably bad. It would be better to verify that failure before replacing the control console key panel. If that Start button is bad, then you can order the console key panel from this page: Maytag Dishwasher Model MDB5601AWS Control Panel Parts . Be sure that you shut off the house circuit breaker for the dishwasher before accessing and replacing internal components.

If that Start button works, I recommend that you check the other buttons using that chart (with the circuit breaker for the dishwasher still shut off ). If all of the buttons are working properly then you will need to replace the electronic control board in the console.

If you do not have a volt/ohm meter, then you can probably fix this problem by replacing that key panel. The black version is relatively inexpensive (around $70).

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 31, 2012
A:

Ok, i got the new control panel. Do you have an install guide? My only real concern is the ribbon sticking off the new panel.

Read More
D -
September 06, 2012
A:

I posted a procedure for accessing the electronic control board in the image below. That will help you access the connection of that control panel to the control board inside that console. Be sure that you shut off the house circuit breaker for the dishwasher before beginning that repair. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
September 07, 2012
See more answers

Top Parts