Model #MDB5130AWW MAYTAG Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Rinse Aid & Soap Dispenser
    3 Results
  • Track & Rack Assembly
    3 Results
  • Tub
    3 Results
  • Pump & Motor
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dishwasher shuts off in middle of cycle MDB5130AWW Maytag Maytag dishwasher

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Yah what is happening is the latch isn't completing the circuit, and that's why everything shuts off. What you would need to replace is the door latch assembly. Im showing for your dishwasher the correct door latch part number is 99002207. On this dishwasher it is required to have two of these. Hope this information has help you. If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Any further questions or concerns. You will have to post a new question because at this time I can not reply to any comments. Again, Thank you for choosing SearsPartsDirect.com.
 

Read More
Samantha A -
Sears Technician
June 23, 2014
Q:

How do you replace the mounting strip? MDB5130AWW Maytag Maytag dishwasher

A:

Thank You for choosing Sears PartsDirect.com. I regret to hear that you are having issues with your dishwasher 
and do understand your frustration. Glad to help out. Im looking at your model number  MDB5130AWW  and you will need to remove the upper rack from the rail. The rails have stops that will need to be removed(#18 in the diagram) The strip will need to slide all the way to the bottom. The rear part of the strip will pop out first and slightly point down and the front part of the strip slide out of wheel mounting plate(#23 in the diagram).If you look at how it looks from the inside of the rack looking at the rear of the strip will help you see how it comes out. The wheels pop out of the old strip as well. Just click the blue link above to be taken to the page. If you have further questions please resubmit your question for further information.
 
Thanks for choosing Sears PartsDirect.com.
 

Read More
Sherman_G_Wallace -
Sears Technician
March 25, 2014
Q:

dishwasher panel flashes MDB5130AWW Maytag Maytag dishwasher

A:

I read that the manual recommends that you turn the power off to dishwasher. When you turn the washer back on, the lights still flash but then push the off button. The lights stopped flashing. Also you may have the lock activated. press and hold the HEATED DRY button for 3 seconds. It is also recommended  pressing and holding down the heated dry button until the light went off. Then it should let you start the machine as usual. Hope this works for you. If none is these work for you, you may want to check the ribbon strip for the control board and the control board itself may be bad. This model appears to be a 2002 model.

If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com and good luck!

Read More
Sherman_G_Wallace -
Sears Technician
October 03, 2013

Top Parts