Model #MDB121RFS2 UNIVERSAL/MULTIFLEX (FRIGIDAIRE) Dishwasher

  • Cover
    3 Results
  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

dishwasher didn't drain

A:

The dishwasher not draining is a problem I can most likely help you with but more detail would be needed.

A common thing to check is the drain hose. If you disconnect the drain hose from under the sink and lower it over a shallow pan gravity should allow the water to drain out when the hose is lower than the water in the tub.

With a model number and a few more details I can help you repair this yourself.

Read More
Fred M -
Sears Technician
June 11, 2010
A:

fridgeaire: Quiet Clean I - MDB121RFS2 - 3.4 amp.

Read More
sheetrock55 -
June 18, 2010
See more answers
Q:

Water will not drain out of machine.

A:

This particular dishwasher has a separate drain motor.

A little more detail about if the drain pump runs and partially drains the water out or if it doesn't run at all would be helpful.

If the drain pump is not running at all then the problem would be a bad drain pump or bad timer and the drain pump is much more likely to fail than the timer.

If the pump seems to run but all the water doesn't drain out then there may be a clog in the sump.

Make sure the drain hose is not kinked.

The 5304475805 drain pump can be obtained from the following link: Sears PartsDirect .

If there are any additional details I may be able to help you further.

Read More
Fred M -
Sears Technician
June 11, 2010

Top Parts