Model #MAH8700AWW MAYTAG Residential Washers

  • Control Panel, Dispenser
    3 Results
  • Door
    3 Results
  • Cabinet
    3 Results
  • Tub - Front
    3 Results
  • Tub Back
    3 Results
  • Supplemental Information
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I fix my Maytag Neptune model MAH8700AWW that won't drain or spin?.

A:

We had a similar ptoblem with our Neptune.The repair person had to replace the "mother" board which is located behind the control panel.One of the resistors was burnt which controlled the logic for the unit to spin.If you can remove the board and look for a brown spot which indicates the burnt resistor.I hope this helps.

Read More
milazzo -
March 20, 2010
A:

From the description you give the first thing to do is check and repair/replace the drain pump.

If the washer doesn't drain properly then it will not be able to spin properly.

You can access the drain pump by removing the rear access panel. The image below will help with this. Remember to unplug the washer first.

If the pump is making noise most likely it is getting voltage. It may be blocked with something or may just need to be replaced.

I hope this information is helpful to you in resolving this problem but submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
March 20, 2010
A:

How do I replace the door diaphragm to a Maytag Neptune MAH8700AWW?

Read More
Anonymous -
November 15, 2010
A:

How do I open lock the door? But won't open door

Read More
Anonymous -
September 27, 2013
A:

ihello i have the maytag neptune front loader washer i used soap chips and thought it was clogged but after pulling the pump out and cleaned it i realized it was not that when i run a cycle the clothes are still extrememly wet i hit the spin cycle and i hear water draining out into the pipe my question is how high is that drain pipe suppose to be could it be the height of the drain pipe if not than what could it be

Read More
keith -
October 14, 2015
See more answers
Q:

Maytag Neptune washer tub fills with water when not using. MAH8700AWW Maytag Maytag laundry

Q:

how remove/replace drum bearings? mah8700aww

A:

Thank you for your inquiry on your Maytag Washer, Model: MAH8700AWW. From reviewing the details on your model, it appears that the drum bearing is only available with the rear tub assembly.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the washer to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
August 07, 2015

Top Parts