Model #MAH55FLBWW MAYTAG Residential Washers

  • Control Panel
    3 Results
  • Door & Shroud
    3 Results
  • Cabinet
    3 Results
  • Cabinet - Rear
    3 Results
  • Outer Tub
    3 Results
  • Spinner Assembly & Outer Tub Cover
    3 Results
  • Base
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information
    3 Results
  • Wire Information
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Wasning machine MAH55FLBWW Maytag Maytag laundry

A:

Thank you for choosing SearsPartsDirect.com. The LR code means "locked rotor" which is just a way of saying the control is not seeing the motor turning. The image below contains the wiring diagram for this washer as you requested but there are some other things to consider. Usually when the LR code is displayed the motor has stopped turning for some reason. By definition the LR code means the control has tried to turn the motor but was unable to. The error code can be caused by to large of load, to much soap/suds in the water or a problem with the spin bearing. The cause of the LR message can be little problem like suds or a major problem like the spin bearing and sometimes it's difficult to pin down. Try running a rinse and spin cycle empty and see if the washer completes the cycle. The 2nd image contains the information on how to enter and run a diagnostic cycle which may help pin the source of the problem down. This test completes all functions of the washer is a short time. It will fill, tumble, drain and spin all is a few minutes. At the end of a successful test cycle a PA should display which means "Passed" and is what you want to see. I hope this helps you! Have a great day.

Read More
Samantha A -
Sears Technician
November 12, 2013
Q:

cannot chnge cycles on my washer mah55flbww

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Joseph P. -
April 30, 2013
A:

thanks for looking into my problem. i am wondering if it is either the control board or the membrane pad.

Read More
reciever -
May 01, 2013
A:

 

Thank you for your question and I understand your concern.

Based on your symptom, I would have to suspect a faulty control panel/membrane switch panel. Try disconnecting the power cord from the wall outlet for a couple of minutes and then reconnect the power and see if you're able to program and start a cycle. If it continues to act the same, the control panel is most likely faulty. 

I recommend calling a service technician to properly diagnose and repair your Maytag washer.

 

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.

Read More
Joey S -
Sears Technician
May 02, 2013
See more answers
Q:

Boot replacement on MAH55FLBWW

A:

I think its great that you are wanting to do some repairs on your own. I did some research and I was able to find a link that will guide you with your repairs. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
June 02, 2012
A:

Bruce - Maytag washers are now manufactured by Whirlpool.

The part you need is item # 18 at the first link below.

It is also available at the second link below and the instructions for fitting it are anawered in the questions beneath the picture.

It is a simple enough task but a lie time consuming. Good Luck

Read More
biguggy -
June 02, 2012
A:

Thanks for contacting ManageMyLife.com. I understand how important it is to have a properly working washer. he entire procedure is shown in the images below. I recommend that you review this entire procedure before you begin attempting it yourself. If you are certain that you can complete this repair, then the procedure below should help you through it.

To order parts please visit SearsPartsDirect.com with the model number.

If you do not feel comfortable repairing this problem yourself, then you can have it repaired at your home by a Sears technician. You may visit SearsHomeServices.com and click on the red Start now button.

Please feel free to let me know if you need further assistance.

Thank you for using ManageMyLife.com.

Read More
Jonathan B -
Sears Technician
June 04, 2012
See more answers

Top Parts