Model #LW3503W2-PLW3503W2A AMANA Residential Washers

  • Graphic Panel, Control/controls
    3 Results
  • Out-of-balance Switch
    3 Results
  • Cabinet Top/control Hood Rear Panel
    3 Results
  • Inlet Hose/fill Hose/mixing Valve
    3 Results
  • Motor/pump/idler
    3 Results
  • Drain Hose And Siphon Break
    3 Results
  • Agitator/washtub
    3 Results
  • Transmission/balancing Ring
    3 Results
  • Outer Tub, Cover/pressure Hose
    3 Results
  • Bearing Housing/brake/pulley
    3 Results
  • Front Panel/base/cabinet
    3 Results
  • Motor Connection Blocks/terminals
    3 Results
  • Power Cord And Terminals
    3 Results
  • Terminals
    3 Results
  • Transmission Pin Tool
    3 Results
  • Seal And Switch Tools
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is my Amana washer going out of balance in spin?

A:

Something like this could be caused by either the suspension springs or the snubber. If oil or lubricant gets on the snubber surface you will loose the friction needed to keep the tub stabilized during the spin cycle. If the snubber #19 checks good I recommend replacing the suspension springs. I have listed other possibilities in the image provided below.

Read More
biker dave -
Sears Technician
January 27, 2010