Model #LTF2140ES0 FRIGIDAIRE Residential Washers

  • Control Panel
    3 Results
  • Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washer that does not spin

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner. Have a great day!

Read More
Alina -
January 05, 2013
A:

I know that it can be very difficult to have issues with your washer. Your washer may have a faulty door lock assembly preventing it from spinning even though it locks. Since your model does not have digital display window in order to display a fault code; the control signals the failure code by flashing the five indicator lights of Door Lock, Wash, Rinse, Final Spin and Control for the first number or letter after the E and the Start indicator light for the second number or letter after the E.

When a failure occurs, the washer will stop or pauses and the control beeps and flashes the five indicator lights to tell the customer that a failure has occurred. The images below will provide the testing and error code information. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
January 06, 2013
See more answers
Q:

Why does my Front Load Washer stop after a few seconds no matter the Cycle?

A:

I know how concerning it is when you are having appliance issues. I researched your question and was unable to find any information that would be helpful. An expert will respond shortly. It usually takes 24-48 hours to receive a response. If you would like to schedule service I have attached the Sears Home Services website below. Have a good day.

Read More
Jackie S -
August 02, 2012
A:

I know that it can be very frustrating to have issues with your washer. It sounds like the problem that you are having is with the main controls. This is the only part that will control both the fill and drain. However, you replace this a it is still not working. I would suggest that you run a diagnostic test on the machine. This will determine what the problem is. This test will also recalibrate the machine, which is something that should have been done when you replaced the board. The images below will provide the test for you. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
August 03, 2012
A:

Ok...I have an Error Code of E56. I have removed and tested the Motor, but it appears to be fine. Do I need to replace the Motor Control Board?

Read More
Edward -
August 06, 2012
See more answers

Top Parts