Model #LSQ9610LW0 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My whirlpool washer stopped working. If I wait a few minutes it will start humming or start to work for a few seconds or so, then stop again

A:

When your experiencing any kind of problems with your washer it can be frustrating because these are expensive appliances. I found a link that may assist you with diagnosing the problem with your washer. I have provided the link below. I hope this helps!

Read More
Jacqueline S -
September 30, 2010
A:

Based on your symptom and details it sounds like you may have one of several possible failures. It could have a bad motor, loose wire connection or you could have something stuck in the drain pump causing the motor to click off on the motor thermal overload. You will need to remove the washer cabinet and remove the pump from the motor and then see if will continue to run. In order to remove the washer cabinet the control panel must be placed in the service position. See images below. There will likely be a screw located a the front of each control panel end cap to remove and then slide the control panel towards you and then lift it up and hinge it over the rear panel. See image below for instructions on how to test the motor and remove the drain pump. Note: Disconnect the power cord from the power source before servicing your washer. Also; you do not have to remove the hoses from the pump before removing the pimp from the motor. Leave the hoses attached and shove the pump over to the left side of the motor and then see if the motor will run in. Note: The motor will not run in the spin direction with the lid switch disconnected or with the lid open.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 30, 2010
See more answers

Top Parts