Model #LSQ9211KQ1 WHIRLPOOL Residential Washers

  • Top And Cabinet/literature
    3 Results
  • Controls And Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
  • Water System
    3 Results
  • Miscellaneous/optional
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Do I need an agitator or agitator mover?

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
October 28, 2011
A:

The tub lean is most likely not related to the poor agitation. There is one counterweight spring and 3 suspension springs. If one breaks then the tub might lean to one side.

The agitator has two parts. The upper part is driven by a plastic "cam and dogs" that cause the upper part to ratchet.

The lower part of the agitator is attached to the transmission shaft and if it is moving poorly then likely the problem is the transmission.

There is a screw on the back side of the console that is removes so the console can be tilted back. The image below shows similar model with the screw in the front.

You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 30, 2011
A:

Thank you Fred for that information. I ordered the agitator( part # 3951632) and agitator mover ( part # 3363003). I recieved the agitator yesterday and I compared the new agitator to my old one and it seems as though one of the tips on top of the new agitator is missing.( looks like it was cut or broke off) I don't know if these tips are to lock or hold something in place or not, but I don't want to put it together and the washer still dosen't work properly because something isn't locked down right. I also pulled up the picture, but because of the angle of the agitator I couldn't tell if it has three of four tips. I couldn't tell anything from the parts diagram.Can you help me again please?

Read More
Linda -
November 10, 2011
A:

There should be 4 tips on top of the agitator. These help hold the upper part of the agitator in place.

Read More
Fred M -
Sears Technician
November 13, 2011
See more answers
Q:

Why is my agitator missing a tip?

A:

Definitely having to do repairs yourself can be a challenge to help in determining if you have the right part I would suggest revisiting Sears parts direct.com where you can view a diagram of all parts still available for your Washer. I have attached a link below. Hope it helps!

Read More
Priscilla V -
November 10, 2011
A:

From the description you give I suspect one of the tabs has broken off. These tabs help hold the upper part of the agitator.

There should be 4 tabs.

Check out the following video for help: Changing the Cam/Dogs .

I hope this information is helpful to you. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
November 12, 2011
See more answers

Top Parts