Model #LSN2000JQ0 WHIRLPOOL Residential Washers

  • Top And Cabinet/literature
    3 Results
  • Controls And Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
  • Water System
    3 Results
  • Miscellaneous/optional
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Whirlpool clothes washer stops in mid-cycle repeatedly.

A:

Good morning... I can fully understand your concern regarding this issue. I did locate a link that will discuss this situation in greater detail. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might wrong with your washer and have a nice day

Read More
Henry -
January 13, 2013
A:

I should have mentioned that I can't enlarge any pages you send a link to even though I have a large screen monitor. Can you give me a link to the actual page or tell me how to enlarge the pages you sent? I really appreciate your help.

Read More
barbara -
January 13, 2013
A:

Thank you for submitting your question. Barbara, based off of your symptoms you could be experiencing a few things. You could have an issue with the lid switch (3949247), clutch (285785), transmission (3360629), or timer (3954071). I recommend checking the lid switch first. The switch can be checked two ways. The first way is with a volt/ohm meter and you can check continuity across the two terminals on the switch. The circuit should show open and closed as the lid is open and closed. If you have no meter then the lid switch can be bypassed to see if it is the problem. The idea is to remove both of the wires from the lid switch and join (jump) them together with a small wire. With the lid switch bypassed you can see if the washer will drain and spin. This video will show you how to remove the cabinet to access the lid switch. To bypass the lid switch install a jumper wire in the lid switch harness connector. Use extreme caution when operating the washer with the cabinet removed. Remember to unplug the washer before accessing and checking the lid switch. If the lid switch test good, then I recommend checking the clutch. Here's a great video on how. You can order any parts from our Sears Parts Direct web site. I hope this information helps. Please reply back to this thread if you require further assistance with this repair. If you do not feel comfortable performing test or repairing this problem yourself, I recommend scheduling for service. You can schedule for service online with our Sears Home Services team. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
January 14, 2013
A:

Thank you so much. It was the lid switch. I never realized I was supposed to hear the switch click when I lifted the lid--apparently it had been going bad for a while. All's well and I'm catching up with the laundry.

Read More
barbara -
January 15, 2013
See more answers

Top Parts