Model #LSG7804AAM MAYTAG Laundry Centers/Combos

  • Front Panel & Control Panel
    3 Results
  • Wiring Information-dryer
    3 Results
  • Front (lsg7804aam & Abm)
    3 Results
  • Front Panel & Control Panel (7804aa &ab)
    3 Results
  • Cabinet-dryer (lsg7804aam & Abm)
    3 Results
  • Door (lsg7804aam & Abm)
    3 Results
  • Tumbler (lsg7804aam & Abm)
    3 Results
  • Gas Valve (lsg7804aam & Abm)
    3 Results
  • Motor-dryer & Blower (lsg7804aam & Abm)
    3 Results
  • Top & Lid (lsg7804aam & Abm)
    3 Results
  • Cabinet (lsg7804aam & Abm)
    3 Results
  • Tub (lsg7804aam & Abm)
    3 Results
  • Transmission (lsg7804aam & Abm)
    3 Results
  • Base (lsg7804aam & Abm)
    3 Results
  • Clutch, Brake & Belts (lsg7804aam & Abm)
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Question and Answers

Q:

trouble shooting a MAYTAG STACKED WAHSER -DRYER LSG-7804-AAM

A:

I understand how concerning this can be especially after replacing different parts and it still not working properly. While you are waiting on an expert to answer your question, I was searching the Sears Parts Direct website on found your diagram so you can see parts you need. You can also speak with a Sears associate to find out what parts you may need. I have attached the links below. Have a nice day!

Read More
Dezeray -
August 18, 2012
A:

Thanks for the schematic. This will be very helpful. I appreciate it

Read More
Barbara -
August 18, 2012
A:

Hello Barbara,

I'm sorry to hear that your washer keeps blowing fuses and I would like to assist you. I have circled the fuse on an attached diagram, check the lid switches for the correct operation. Be sure to unplug the machine prior to testing or repair! It is usually the lid switches that cause this issue, but as you can see from the diagram, that circuit goes all over the place. After unplugging the machine and opening it up, use a multimeter set to ohms to find the source of the short. It is usually the lid switches, but I have found disconnected terminals and broken wires anywhere along the circuit causing this.

Please let me know if you would like any further assistance.

Jerry C

Read More
Jerry C -
Sears Technician
August 20, 2012
See more answers

Top Parts