Model #LLT8233AW1 WHIRLPOOL Residential Washers

  • Top And Cabinet
    3 Results
  • Controls And Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
  • Water System
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to install timer for Whirlpool washer, Model Number LLT8233A

A:

It's always great to hear that more people are wanting to do more do it yourself projects with their appliances. I was able to locate some information on the project that you are wanting to do. I hope that it helps and provides great information upon replacing the washer.

Read More
celene -
January 07, 2011
A:

Thank you for the question.

I should be able to help you with replacing the timer in the washer. First, make sure you unplug the washer and remove the know by pushing in and turning it counter clockwise. Now you can remove the dial by sliding it off the timer shaft. Then remove the two screws in the front lower corners of the console. Next, pull the console forward slightly and then lift it into the service position. Now unplug the wires to the timer and flip the console back down. Then remove the two mounting screws that are located behind the dial. Next, hold the new timer in position and install the mounting screws. The screw holes might not have threads cut yet but that is fine the screws will still go in. they will cut the threads as you turn the screw. Then just reassemble the washer in the reverse order.

I hope this is helpful.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
January 09, 2011
See more answers
Q:

Why does the agitator slow down when clothes are added on my Whirlpool washer model number 11T8233AW1?

A:

More than likely if you tilt the washer a couple of inches and there is some rubber shavings visible. This is a sign of a worn out motor drive coupler.

I would suggest scheduling service at 1-800-803-6775 to have a technician diagnose and repair your washer.

Read More
Luis L -
Sears Technician
February 22, 2010

Top Parts