Model #LHW0050PQ1 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Basket And Tub Parts
    3 Results
  • Pump Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

slow spinout LHW0050PQ1 Whirlpool Residential washer

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your washer and I do understand your frustration. Glad to help out. I'm looking at your model number lhw0050pq1 and from your description I would suspect an issue with the spin speed switch. If you have a multi meter you are able to test the switch. It can also be an issue with the motor that spins the drum as well. If you do not have a meter or do not know how to test electrical items I do not recommend that you attempt to do so. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

 

Read More
Sherman_G_Wallace -
Sears Technician
December 05, 2014
Q:

LHW0050PQ1 handle broke off LHW0050PQ1 Whirlpool Residential washer

A:

Thank you for contacting SearsPartsDirect.com with your question about your Whirlpool washer. I am so sorry the handle broke. I understand your concern about getting all the parts needed so you can get this machine repaired and working again quickly. I will be happy to help you with this. 

If the handle snapped during normal use, then you will only need to replace the handle. If, however, the handle broke because the door lock was still engaged when the handle was pulled, then you should check the lock mechanism for damage also. Keep in mind that at the end of a cycle, and also if you stop the washer during a cycle to add something, the door remains locked for two minutes immediately after the washer stops. Pulling on the handle during this two minute time period can damage the handle, the lock and the door. If the washer still operates the locking mechanism should be okay. It is a safety device and the washer normally would not run if it is damaged. 

Be sure to check to door for any cracks, especially where the handle attaches. If you see cracks in a part of the door, that part should also be replaced to prevent leaks.

I hope this answers your questions. If you need further assistance, please resubmit your question with additional details. Thank you for choosing Sears, we appreciate your business. 

Read More
Rachel Morgan -
Sears Technician
April 07, 2014
A:

How do you put the handle on? Does the door need to be disassembled?

Read More
Bill -
May 21, 2014
See more answers

Top Parts