Model #LGQ9508PW1 WHIRLPOOL Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • 8318272 Burner Assembly, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer will not stay heated during complete drying cycle

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
February 21, 2012
A:

You probably have weak gas valve coils that are causing this heating failure. The theory of operation for that gas burner ignition system is shown in the 5 images below. Since the burner initially ignites properly, this indicates that all of the other components in that system are apparently okay. Replacing the gas valve coils will probably fix this heating problem. You can order a kit that has both coils from the Sears PartsDirect website . That kit part number is 279834. Here is a direct link for that part: Gas Valve Coil Kit .

Here is a link for a repair video that shows how to replace those valve coils: Dryer Gas Valve Coil Replacement .

This information should help you fix this dryer heating failure. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician complete this repair, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 21, 2012
A:

Here are the additional 2 images for that gas burner theory of operation.

Read More
Lyle W -
Sears Technician
February 21, 2012
A:

I have the same issue. I ohmed out all the thermistates and they tune out good. The thermistate next to the thermal fuse on the exust side and it ohms out at 4.91 k ohms. Is this good for this module number.

Read More
ronnie -
April 28, 2012
A:

Hello Ronnie. Your details seem to indicate that you measured that resistance through the thermostat heater that is on the top of that operating thermostat switch. That resistance is within the normal range. That thermostat heater will not prevent the dryer from heating. You should measure near zero ohms through the outside spades on that operating thermostat. The wiring diagram for that model is shown below. I recommend that you check the resistance through the switch part of that thermostat. I also recommend that you check the heat switch for continuity if that igniter is not glowing. Reply with additional details if you need more help.

Read More
Lyle W -
Sears Technician
April 30, 2012
A:

Be sure that you unplug the dryer before accessing internal components.

Read More
Lyle W -
Sears Technician
April 30, 2012
See more answers

Top Parts