Model #LGB6000PQ1 WHIRLPOOL Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • 8318272 Burner Assembly
    3 Results
  • Bulkhead Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer not drying

A:

It can be very frustrating when your dryer will not heat properly. I did a broad search and provided a link to a similar question. I would suggest that you provide a little more information such as the make and complete model number of your product, so your expert will be able to provide you with the best possible answer. Just click on reply down below, where you can provide the additional information.

Read More
Julio -
October 26, 2012
A:

When a gas dryer runs but doesn't heat the key to the problem is knowing if the ignitor is glowing. You can check this by removing the small square plug on the front panel. See the 2nd image for more on this. If the ignitor is not glowing the thermal fuse is the usual suspect. The wiring diagram in the 1st image may help you. From the parts you have replaced with no change I suspect the timer or even motor switch is at fault. Do you have a meter to check continuity? Remember to unplug the dryer first. The ignitor should glow, click off then glow again.

Read More
Fred M -
Sears Technician
October 28, 2012
A:

Yes, I now have a tester

Read More
chuck -
October 28, 2012
A:

Great to know you have a meter. I would still start by removing the small plug and visually checking if the ignitor is glowing and clicking off. Let me know and we'll move to the next step.

Read More
Fred M -
Sears Technician
October 29, 2012
A:

Yes, it glows, and, cycles of and on. burner not lighting. Chuck

Read More
chuck -
October 29, 2012
A:

If the ignitor is glowing and clicking on and off then the problem will be with the gas valve or gas coils. The coils can be checked for resistance/continuity if a meter is available. If no meter is available then replacing the valve would be the best choice.

Read More
Fred M -
Sears Technician
October 30, 2012
A:

secondary coil: I get continuity between blue and black but not white to blue or white to black.

Read More
chuck -
October 30, 2012
A:

Then most likely the coils need to be replace. Both coils come in a kit for about $23 dollars. The kit part number is 279834 and can be obtained from the following link: SearsPartsDirect .

Read More
Fred M -
Sears Technician
October 31, 2012
See more answers

Top Parts