Model #LFX25960ST LG Bottom-Mount Refrigerator

  • Case
    3 Results
  • Freezer Parts
    3 Results
  • Refrigerator Parts
    3 Results
  • Doors
    3 Results
  • Dispenser
    3 Results
  • Ice Maker
    3 Results
  • Ice Bank
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Replace Water Line on LG Refrigerator

A:

Replacing parts on appliances can be quite a mystery without instructions. While you are waiting on an expert to answer your question, a suggestion I have is to add model number to this thread so you can get a better answer from the experts!

Read More
Dezeray S -
January 11, 2011
A:

I am trying to get that clarified...(it's my neighbor's). The number she gave me was LGC26905TT. I'm not finding that number anywhere. She is supposed to be getting back to me and I'll post it as soon as I have it. I didn't know if all LG's had the same set-up or not.

Read More
Jaybop -
January 11, 2011
A:

The model number is LSC26905TT. I think the part I need is 616F. It is the larger tube on the back. It looks fairly straight-forward, but didn't want to get it apart and find any surprises when I went to connect the tube. It looks like other folks have had problems with holes in this tubing?

Read More
Jaybop -
January 11, 2011
A:

Thanks for providing that updated model number and the part that you are trying to replace. You can order new tubing from the Sears PartsDirect website.

I recommend that you repair this failure by cutting the ends of the water line at the top and the bottom outside of the area where it is leaking. Use some fittings (John Guest fittings) to splice in a replacement line of tubing. Be sure that you shut off the water supply and unplug the refrigerator when completing this repair.

You should be able to find fittings to splice the water line into place at your local hardware or plumbing supply store.

If you were to replace the whole part, you would need to pull the cover shown in the first image below. After removing the screw, you will need to release the tabs that are shown in the second image. You can then remove the cover. The third image shows the water lines going into the refrigerator cabinet with that cover removed. The lines go into the refrigerator cabinet and connect to the filter housing (Key 626A in the 4th image). You will need to disconnect that line and connect the new one. To access that housing, you will need to remove the light bulb cover, light bulbs and control housing in the top of the refrigerator cavity. The other end of the line that you are replacing is probably hooked to the inlet water valve assembly shown in the 5th image. The 6th image shows how to remove that component. You can see that replacing that entire water line can be an extensive project. That is why I recommend splicing in a replacement run of tubing.

Be careful when working with the water lines. Failure to properly connect the water lines can result in a leak that will cause damage to flooring or counters.

If you need more help, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 12, 2011
A:

Here are the additional images.

Read More
Lyle W -
Sears Technician
January 12, 2011
A:

Hi Lyle.. I have a question regarding the valve. I've posted a question already ..but have not heard anything.. I have and LG25950 and it has stopped making ice. per biker mike (expert) here he replied to another person saying that the water valve might be frozen. I've moved the refrig, and can see the valve, but don't know what to do next or how to remove it.. He also mentioned to flush the line.. before hooking it up and again... I don't know how.. could you assist me ?

Read More
Lori -
March 31, 2011
A:

The water valve itself is probably not frozen. The water tube that fills the ice maker could be frozen. I read the answer that Expert Jimmy provided for your question. He provides some good information. See if the ice maker has ice cubes in it. I provided some technical information about that ice maker in the image below. You can manually cycle the ice maker by pressing and holding that fill adjustment button for 3 deliberate seconds. See if you can get the ice maker to cycle in this manner. If not, then the ice maker module will probably need to be replaced. If the ice maker cycles but does not fill, you could have a problem with the water valve. You would need to determine whether the water valve is getting voltage during the fill portion of that manual cycle process. I recommend that you have a technician check this type of problem. That type of diagnosis will require a live voltage check using a volt/ohm meter. Those types of checks are dangerous. I provided a link for the Sears Service website below this reply. If you decide to have the refrigerator serviced, you can use that link to schedule a technician. If you want to continue to troubleshoot and repair this problem yourself, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
April 01, 2011
A:

Lyle W , the line on the back of my lg French door refer also had a pin hole leak. I repaired that section of line. Another pin hole developed in the old line. I'm stumped. What is causing this? The first hole developed almost immediately after we changed the filter. Could that have done something to the pressure? Lfx25960st

Read More
Dan -
January 23, 2012
A:

Hello Dan. Changing that filter would not affect the water pressure through those water lines in a manner that would cause a leak. It could be a coincidence that the leak occurred immediately after changing that filter. You may want to shut off the water supply and remove the water supply line on that back of the refrigerator. Place the end of the water supply line in a bucket and check the water pressure and flow from the end of that water supply line. The water pressure inside the refrigerator will not be more than what you see from the end of that water supply line. If that water pressure is normal then I don't think that a water pressure problem is causing your leaks. That being said, there is a chance that the water supplier was conducting some maintenance or repairs on the water supply in your area and that the system experienced a temporary spike in water pressure. You can check on that issue. If you do not find excessive supply pressure, then the water line failures were likely caused by a failure or fatigue of the water lines. I hope that this information helps. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
January 23, 2012
A:

Thanks Lyle W. I Would like to change that entire line. The bottom is easy, but the top enters the back of the refer into styrofoam. Can you explain how to disconnect the top end? It must connect to the filter, but I do not know how to access that point. Any help is appreciated. Dan LG. Lfx25960ST

Read More
Dan -
January 23, 2012
See more answers
Q:

LG refer. LG 25960 ST

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

I do apologize we will need the full model number in order to get service instructions. The model number will be located on the unit itself. 
Please resubmit your question with the model number and we will be able to give you repair information. 

 
You can also visit searpartsdirect.com for parts, diagrams, and repair information.

 

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
July 13, 2015
A:

Sorry...LG refer. Model # is LFX25960 ST

Read More
Michael -
July 13, 2015
See more answers
Q:

Ice maker is not making ice. Water is dispensing. Lg Model # LFX 25960ST

A:

I'm sorry to hear that you are having some difficulties with your ice maker. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you

Read More
Jackie S -
December 29, 2011
A:

Thank you for your question. I know it can be disappointing when the icemaker stops working. There are various reasons that can cause this icemaker to stop working.

  • The icemaker itself
  • The water valve
  • The main board
  • The temperature in the icemaker compartment
A good check will be to cycle this icemaker manually and see if it will cycle completely and fill with water. To cycle this icemaker, press and hold the water level button for 3 seconds (see picture). If it cycles ok and fills, it indicates a problem with the icemaker or the temperature in the compartment is too warm (above 12 degrees). If it cycles but does not fill and you can hear a humming sound, the water valve inside the door will need to be replaced. If nothing happens, some voltage checks will need to be made at the board and icemaker. I recommend having a technician make these checks. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
December 30, 2011
A:

Having this same refrigerator, I followed your instructions, manually trying to see what the problem was. After following your instructions my frig did the first reaction, "if it cycles ok and fills, it indicates a problem with the icemaker or the temperature in the compartment is too warm (above 12 degrees)." I was wondering if you would be more specific on what the problem could be with the ice maker. I don't think the compartment is the problem (above 12 degrees) of course it may be. My frig has the error code of 1F as well. Thanks for your help.

Read More
Joanne -
June 05, 2015
See more answers

Top Parts