Model #LER7620LW0 WHIRLPOOL Residential Dryer

  • Top And Console/literature
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why won't my dryer turn on after very wet clothes were put in by son?

A:

The dryer not starting can keep you from drying your freshly washed clothes. I am adding a link below to help you with your question while you wait for your expert response.

Read More
Joseph P. -
February 06, 2012
A:

Thanks for contacting ManageMyLife.com. I understand how frustrating it is to have a dryer not working. We are here to help. It sounds like when your son put in some soaking wet clothes into the dryer, water dripped on to the motor. There is a good possibility if you unplug the dryer for 24 hours the motor my dry out and be okay. Unfortunately, without the model number we can on y provide general information. Please respond back to this thread with the complete model number so we can help you determine what may be wrong.

Please feel free to let me know if you need further assistance we are here to help.

Thank you for using ManageMyLife.com.

Read More
John H -
Sears Technician
February 08, 2012
A:

.Found the problem broken belt. My model number is 11063954101-Kenmore Elite. Could I get instuctions and a diagram for putting the belt on please

Read More
Debra -
February 09, 2012
A:

Debra, Please follow these instructions . To replace the belt you will need to gain access to the inside of the cabinet. First disconnect electrical power to the dryer. Open the dryer door & remove the lint screen. Remove the end caps from the console by pulling them straight off. Remove the screws that go down at an angle securing the console to the top panel, one on each side. Lift the console up while pulling forward. Carefully swing the console up & over. Remove the 3 screws along the rear edge, holding the rear panel to the top panel. Slide the top panel forward to disengage the front lip, lift up & remove the top. Unplug the door switch from the harness. Use a putty knife to release the clips securing the toe panel, these are located on the top of the toe panel about 2-3 inches from each side. Now you will need to remove the 4 screws securing the front panel to each side panel, one on each side, top inside & bottom outside. Remove the front bulkhead by removing the 4 screws, one in each corner. You should now be able to slide the belt around the drum. Loop the belt around the motor pulley, groove side down & stretch the idler pulley spring allowing the belt flat side to rest against the pulley wheel. You will need to turn the drum clockwise to align the belt. Be careful of the sharp metal edges. Reassemble in reverse order.

Read More
John H -
Sears Technician
February 11, 2012
A:

John H. the same thing happened to me today. My dryer quit working after my son put soaking wet clothes in the dryer (they went back into washer to finish spinning). My dryer quit working in the process of him trying to dry them. What could be wrong or could I possibly do to try to fix this myself? My model # is LER7620LW0 - Whirlpool.

Read More
Briana -
November 04, 2012
A:

Briana, I suspect water dripped on the motor. If there is no sign of life most likely the thermal fuse blew. You would have to unplug the dryer and remove the back. The thermal fuse can be checked with a multimeter. The image below will help you do this.

Read More
John H -
Sears Technician
November 05, 2012
See more answers

Top Parts