Model #LEN2000JQ1 WHIRLPOOL Residential Dryer

  • Cabinet
    3 Results
  • Top And Console
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Need to know how to replace belt on Whilpool Electric Dryer Model # LEN2000JQ1

A:

When it comes to replacing parts on your Dryer it can be tricky with out any instructions. While you are waiting on an expert to answer your question, I found a great link in the ManageMyLife.com website. Click here. Hope this helps!

Read More
Dezeray S -
July 13, 2013
A:

Thank you for your question and I understand your concern.

In order to access and replace the drum belt will require removing the front door panel and not the back panel or the lint duct.

Disconnect the power cord from the power source. Pull out the lint filter and remove the two screws that were hidden by the lint filter. The top panel must be released and hinged open. Located near each corner of the top between the top and the front panel is spring clip. Use a putty knife to push inwards on the retainer clip and while pushing in, raise that corner up a little and do the same to release the other side of the top. Raise the top and let it rest up against the wall. On the upper right side of the right side panel will be a quick disconnect harness plug connected to the door switch which will need to be disconnected. Remove the screw located at the top of the right and left side panel securing the front panel. Tilt the top of the front panel out a little and then lift it up and off the two hanger brackets and set the front panel out of the way.

You now have access to install the belt over the drum and the motor and idler pulley. I added three images below to reference.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

Read More
Joey S -
Sears Technician
July 15, 2013
See more answers
Q:

I am replacing the thermostat on my Whirlpool dryer #LEN2000JQ1. The new thermostat #3977767 isa substitute and wired differently from the old one.

A:

Having to replace parts on your dryer can be difficult. I have done some research on the Manage My Life website and have have located a similar links that you may find helpful towards your issue. While you are waiting for a detailed reply from an expert I have provided the links below. Hope this helps!

Read More
Priscilla V -
May 09, 2012
A:

Here is a video that shows how to replace that thermostat: Dryer High Limit Thermostat Replacement . You should not need the jumper wire that comes with that kit. If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
May 10, 2012
See more answers

Top Parts