Model #LE9200XWW0 WHIRLPOOL Residential Dryer

  • 3 Results
  • 3 Results
  • 3 Results
  • 3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Where is the heating element located on my Whirlpool dryer?


The heating element (key#17) is located in the right rear lower corner as you are standing behind the dryer. You can access it by removing the rear dryer panel. (See image below)

NOTE: Disconnect the power cord from the power source before removing the rear panel.

To remove the heater:

  1. Disconnect the power cord
  2. Remove the rear panel
  3. Remove the screw (key#74) securing the heater housing (key#14) to the bulkhead.
  4. Disconnect the heating element wire leads
  5. Slide the heater housing up about 1 inch and then pull the bottom outwards and down.
  6. Remove the screw (key#13) and slide the heating element out of the heater housing.
  7. Reverse the procedure to install the new element and panel.

Read More
Joey S -
Sears Technician
March 04, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show