Model #LDE713 MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Front View
    3 Results
  • Rear View
    3 Results
  • Door
    3 Results
  • Tumbler-gray
    3 Results
  • Tumbler (beige)
    3 Results
  • Heater
    3 Results
  • Motor Drive
    3 Results
  • Motor Drive-thermostats
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

No Heat Dryer

A:

I am sorry that you are having some difficulties with your dryer not heating and I will be happy to help. I did some research and I was able to find a link with a similar question. Click here for the link. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
August 07, 2013
A:

Thanks for contacting mange my life about your dryer model LDE 713; sorry you are having a problem, I will be glad to assist you with this issue. There could be several causes for the non-heating issue you are experiencing. I will cover a few things you should be able to check before calling for service. First you should verify the power supply to the dryer, the wall outlet should be supplied with 240 volts ac = - 5%. If you do not have a high quality volt/ohm meter to test, reset your breakers and test the dryer for heating. One of the most common failures is the heating element, again you can test this with your volt/ohm meter (it should show continuity when isolated. If you have no meters look closely at the element for breaks or discoloration of the element itself. Broken or burn wires in the heating circuit are the next most common issue. You can visually check all the wiring in the heating circuit starting at the terminal block where the power supply attaches to the dryer.  Other components could be bad as well there are a couple thermostats in the circuit that should be tested if all other checks and test are positive. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services. Ron H.

Read More
Ron H -
Sears Technician
August 08, 2013
A:

I see only 1 breaker, is this normal? Can u send me the page that shows how to remove the back panel? Thanks.

Read More
Kris -
August 22, 2013
A:

Hi Kris, with a 240 volt ac circuit there should be a double breaker, meaning there are two breakers that are connected together to supply the voltage needed, each supplies 120 volts ac min. These breakers will be side by side in the main breaker box. The back of your dryer does not come off, there are accesses to the power terminal and the motor area both with covers held on with screws. To access the components you will have to go through the front of the dryer. Raise top find screws near inside top of front cover. First you should verify proper voltage to the dryer. Ron H.

Read More
Ron H -
Sears Technician
August 23, 2013
See more answers

Top Parts