Model #LDE212 MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Front View
    3 Results
  • Rear View
    3 Results
  • Door
    3 Results
  • Tumbler-gray
    3 Results
  • Tumbler-beige
    3 Results
  • Heater
    3 Results
  • Motor Drive
    3 Results
  • Motor Drive-thermostats
    3 Results
  • Export
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do access the heating element on a Maytag model LDE 212 dryer?

A:

To access the element you first remove the front panel. Unplug the dryer and notice two screws on the bottom corners of the front panel. Remove the screws and pull out on the bottom of the front panel. Once you have the panel pulled out about 75 degrees two clips that hold the top will release and you can remove the front panel.

With the front panel gone look for two bolts holding the top panel down. Remove these bolts and the top will lift up.

To access the element you will want to remove the drum. Behind the front panel is a front tub support held on by 4 screws. Remove the screws and remove the tub support. At this point you can release the belt and remove the drum to access the element. Take a moment to check how the belt is routed before removing it.

I hope this information is helpful to you but submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 23, 2009

Top Parts