Model #LCE4332PQ1 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Transmission, Motor And Pump Parts
    3 Results
  • Water System Parts, Miscellaneous Parts, Optional Part
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washer finished? LCE4332PQ1 Whirlpool Residential washer

A:

I should be more specific. The water level icon blinks and all the cycle selection lights are on. There is no error code as this is a simple washer without an area to indicate time remaining or errors. I do not believe the cycle is done at this point, because the clothes are still very damp but there is no water in the washer.

Read More
Kasi -
February 16, 2014
A:

The washer is not spinning when the lights blink.

Read More
Kasi -
February 16, 2014
A:

Thank you for your question and I understand your concern.

Based on your symptom and details, the washer has detected an error or failure.

If one of the 4 cycle lights is OFF and the other three cycles lights are ON along with the water level LED flashing, this would indicate a fault/error code. For example: During a Slow Fill error, the Delicate and TEMPERATURE LEDs are off, the WATER LEVEL LED blinks, all other LEDs are on. If this is case, check the water supply and also check the filter screens in the hot and cold inlet ports on the back of the washer. You will need to disconnect the power cordand turn off the hot and cold water. Remove the hot and cold fill hoses from the back of the washer and then check and clean any debris on the filter screen.


Depending on the type of failure, the washer will not likely complete the cycle. I recommend calling a service technician to properly diagnose and repair your washer.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service by calling 1-800-4-MY-HOME. 

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
February 18, 2014
See more answers
Q:

Maytag model LAT8624AAE timer problems LAT8624AAE

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when  there is trouble with the appliances
 
Glad to help out.   Im  looking at your Whirlpool washer  model number LCE4332PQ1.

Sorry to hear that you are having troubles with the machine going into all the cycles that it should.  On this case it is the electronic control board  you will be needing to fix the problem.

Electronic control board for model lat8624aae

If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com
 

Read More
Larry L -
Sears Technician
February 18, 2014
Q:

Why is my machine nit making noise and intaking water, but comes on#lce4332pq1

A:

Hi,

Thanks for contacting  ManageMyLife.  I understand how frustrating it is having trouble with your appliance.

Well the very first thing is the water fill so if the control is lightening up I would suspect the water fill valves.  Since this a hard washer to get to since the top must be removed and all the harness run up into the top panel. You would need to remove it and see the harness and check power to the board. 

It may be better to have a sears technician out to check the washer out. 

Thank you for using ManageMyLife.com.

Bill

Read More
Bill__W -
Sears Technician
October 15, 2013

Top Parts