Model #KUDS24SEBL3 KITCHENAID Dishwasher

  • Door And Panel
    3 Results
  • Control Panel
    3 Results
  • Door And Clutch
    3 Results
  • Lower Washarm And Strainer
    3 Results
  • Heater
    3 Results
  • Fill And Overfill
    3 Results
  • Upper Wash And Rinse
    3 Results
  • Tub And Frame
    3 Results
  • Pump And Motor
    3 Results
  • Upper Rack And Track
    3 Results
  • Lower Rack
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dishwasher model # KUDS24SEBL3 only cycle that will work is rinse how to trouble shoot i have a voltage meter and am prepared to make this repair

A:

I'm sorry to hear that you are having some difficulties with your Dishwasher. I did some research for you at Managemylife and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below.

Read More
James -
January 11, 2012
A:

The good news about the rinse cycle working is that the fill valve, circulation motor and drain motor are all working.

First step in troubleshooting is can you select all of the cycles and options. You should be able to select all of the cycles and options. If you can't then the interface/console may be the problem.

If all of the cycles seem to work then next try to enter and run the diagnostic test cycle shown in the image below.

Let me know how the test goes and we'll try and figure out the next step.

Read More
Fred M -
Sears Technician
January 12, 2012
A:

Thank you for the prompt response. I printed the diagnostics test sheet, and will enter the key sequence for the Factory Diagnostics and see what the display panel says. Since it doesn't have a alphanumeric display, what I am looking for? Do I have to record the sequence of LED lighting as it goes through the test, or just the final LED lighting after the diagnostics is through?

Read More
po -
January 12, 2012
A:

I pressed the factory diagnostics key sequence, and the machine went through the cycles according to your diagram. After the few minutes it took, it went back to standby, at which point I started the Normal Washing cycle, and it is working now. So, perhaps all the machine needed was just to be reset. I don't know how long this fix will work, but I will take it a wash at a time. Still don't know what make it hang up in lah-lah land in the first place. I am glad it was such a simple fix.

Read More
po -
January 13, 2012
A:

If you run more than 3-4 cycles you should be okay. If there is a water heat problem then the machine may fail again.

Read More
Fred M -
Sears Technician
January 14, 2012
See more answers

Top Parts