Model #KUDS03CTSS0 KITCHENAID Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm And Strainer Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to clean the filter KUDS03CTSS0 Kitchenaid Dishwasher

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dishwasher. Upon researching model KUDS03CTSS0;  the filter is permanently attached to the accumulator assembly, in order to access the accumulator assembly you will need to unplug the dishwasher power cord. In order to remove the filter/flowplate assembly you will need to remove the screw in the center of the wash impeller and then remove the impeller. Once the impeller has been removed then you can lift the filter/flow plate assembly out.

I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
June 02, 2015
Q:

Door won't latch KUDS03CTSS0 Kitchenaid Dishwasher

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Henry -
July 30, 2013
A:

I know that it can be very frustrating to have issues with your dishwasher. Make sure that the latch strike on the top of the tub is not bent upward. You may try bending this latch strike downward to see if the door latch will engage properly. Check the leveling of the dishwasher. If the dishwasher is not "racked" properly, then the tub and frame can be bent in such a way that the latch is not engaging the strike properly. The vent in the door must be open at the beginning of the cycle or the pressure can cause the door to pop open. The inner door or hinges can be slightly bowed and cause this problem. If you have little ones running about the house they can sometimes sit on the door and cause this problem. Also, make sure the door is completely shut at the beginning of the cycle. The door will require a little more push to close it until gaskets get pushed in and formed by the door closing. When you push the door shut you should hear a click when the latch latches. If this is not helpful, then I recommend replacing both the latch strike and the latch assembly in the door to avoid further problems.

The latch is part number W10077360 and the strike is part number W10077370. These are available at Sears Parts Direct.

If you would like to schedule for service, here is a link for the website: Sears Home Services . Thank you for using Manage My Life.

Read More
Desiree -
Sears Technician
July 30, 2013
See more answers

Top Parts