Model #KUDP01FLSS0 KITCHENAID Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm And Strainer Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Replacing Kitchen Aid dishwasher front panel (how to)

A:

When replacing a major part on a dishwasher I know how important it is to have detailed information to make the project much easier. While you are waiting for your expert answer, I suggest you add to the thread of this question and include the full model number of your appliance so that the expert can provide you with a more detailed answer. I did manage to find a link that will provide you with some good information to help you with your question. I hope my link is useful.

Read More
Joseph P. -
June 08, 2011
A:

According to the parts diagram, this appears to have a console with the buttons on the very top of the door.

You can view the parts diagram for the door panel and other components on the Sears PartsDirect website. This parts diagram should help you remove that front panel along with your observation of the dishwasher.

Shut off the circuit breaker for the dishwasher to disconnect electrical power. You will see screws in the inner door panel that attach the console and front panel to that component. Remove the screws in that inner door panel to release the console and the front door panel. You may need to transfer the handle and the nameplate to the new panel. Reassemble the dishwasher in reverse order.

I hope that this information helps. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
June 09, 2011
A:

Thanks Lyle, the operation was successful. I removed the brushed stainless steel panel that had minor cross grain abrasions and took it to a machine shop that does deburring.They belt sanded and brushed it and it looks like new. $40 sure beats paying $400 to replace it. One more new question. The door at the lower hinges squeaked before but now it is really loud. It started getting louder after I removed the panel and moved it. Any thoughts on how to quite it down?

Read More
Michael -
June 10, 2011
A:

Glad to hear that you got the panel fixed. If the hinges at the bottom of the door are squeaking due to metal rubbing against metal, you can normally fix that type of noise by lubricating the hinges with some oil or silicone lubricant. If you have some 3 in 1 oil, that type will work. You could also use a small amount of cooking oil (such as Canola oil) to quiet that type of squeak. If the springs for the hinges are making noise, you will probably need to replace those components to fix this problem. If necessary, you can shut off the circuit breaker and water supply to the dishwasher then pull it out to isolate the cause of the squeak. Let me know if you need more help with that problem.

Read More
Lyle W -
Sears Technician
June 11, 2011
See more answers

Top Parts