Model #KUDP01FLBL3 KITCHENAID Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm And Strainer Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Miscellaneous Parts Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kitchenaid Dishwasher will not go through all cycles

A:

After replacing the electronic control board on your Kitchen-aid Dishwasher, you would think your Dishwasher would be functioning properly. As frustrating as it may be, I am here to help. Managemylife.com is a great resource for issues with a Dishwasher that will not advance to the drying cycle. I researched your question and I provideded some links that may help while you wait for an expert answer to your specific question.

Read More
Anna T -
February 28, 2012
A:

Check that part number on the control board to make sure that you installed the correct one. The part number should be 8564543. Shut off the house circuit breaker for the dishwasher before accessing internal components. I assume that you know how to access that control board since you replaced it but I provided a basic procedure in that third image below in case you need it. I recommend that you check that part number and verify that you used part 8564543 as the replacement control board.

If that part number is correct, I recommend that you check the wiring connections on that control board. The second image shows the wiring diagram for that control board. Make sure that all wiring connections are secure.

If you find no problems with those issues, I recommend that you check to see if that heating element is working. The cycle will stall if that heating element is not working or the thermistor (temperature sensor) is bad. You can use the diagnostic test shown in the first image to test that thermistor (see Note 2 on that test).

If that heating element is bad or the thermistor has failed, then you will need to replace those components. You can order parts from the Sears PartsDirect website. Be sure that you shut off the house circuit breaker for the dishwasher before accessing and replacing internal components.

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician examine and the repair the dishwasher, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 29, 2012
See more answers

Top Parts