Model #KUDI02CRBS3 KITCHENAID Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm And Strainer Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

kitchenaide kudi02crbs3 won't run won't start when door is latched and normal wash is pressed

A:

I understand the concern with the dishwasher not operating & how it's an inconvenience. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Yadira B -
November 13, 2012
A:

disregard above problem, problem was latch. thanks, bill

Read More
bill -
November 14, 2012
A:

The lights at least means the thermal fuse/bi-metal is okay. The light above the start button flashing may indicate a problem with the two door switches. The door switches would be a good place to start. If not the switches then the control may be at fault. The water valves, circulation motor, drain motor don't usually all fail at the same time. If a meter is available the door switches can be checked for continuity when the door is closed. Remember to turn the power off first. This would be a good place to start. Let me know how it goes.

Read More
Fred M -
Sears Technician
November 14, 2012
See more answers
Q:

kitchenaide kudi02crbs3 repeatedly runs[repeats] wash cycle.

A:

ManageMyLife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide the detailed model number so your expert will be able to provide you the best possible answer. Just click on reply below and the provide the required data.

Read More
Priscilla V -
November 14, 2012
A:

Two hours in the wash cycle is a little excessive and may indicate a problem with the water heat cycle. It can be normal for new dishwashers to stall to heat the water but two hours is about a 1 1/2 hours to long. Water heat stalls are usually 15-20-30 minutes and not two hours. If the washer has been stuck in the wash cycle for two hours open the door and see if the water is hot with steam or cool. The images below contain the instructions to run a diagnostic cycle. If this is successful then the control is likely okay. A water heating problem can be the control, thermostat or heater problem. Each can be a do-it-yourself project and each can be checked with a meter if one is available and you are comfortable using it. Remember to turn the power off first. Let me know how things go and we'll decide the next step.

Read More
Fred M -
Sears Technician
November 14, 2012
See more answers

Top Parts